z
zeldathemes
pitoftharkun:

teadrunktailor:

feralworks:

Steps are as follows:
Buy some crepe wool. It comes in a braid and most places let you buy it by the inch. I usually buy 2 feet at a time, but you’re probably only gonna need around 4 inches for one beard (get extra! you don’t want to run out mid application!) I buy mine from a local costume shop, but lots of places sell it online.
Unravel about 6-7 inches of the braid. You’ll notice that the hair is super wavy. You need to iron it first! Don’t skip this step or you’re going to end up with one crazy beard. I sandwich the braid in between two pieces of broadcloth so the iron isn’t actually touching the hair, spritz the cloth with water. Put the iron on the end of the hair and pulling the rest of the braid to straighten it, then move the iron up the length of the hair. In the end it will still have a little bit of a wave to it, but nothing like before.
Clean your face really well! Any residue or oil is going to cause the adhesive to have trouble sticking.
Adhesive: I use Prosaide. You can use other adhesives like spirit gum, but I’ve found that it doesn’t hold as well and tends to need to be touched up throughout the day. Prosaide is a medical grade adhesive and sticks like nobody’s business.  Be sure to buy some adhesive remover for later too!
Start applying the adhesive to your sparkling clear face. I usually only apply about a square inch or two at a time. Paint it on using a cheap paint brush (you will probably throw this away afterwards) in the shape of your beard. Do not touch the glue. It is super sticky and will stick to everything. I start with my chin (underchin).
You want to work your way from the bottom to the top. This is important because you will be layering the beard and it’s easier to lay the hair on top than to try to get it underneath the previous layer.
Allow the glue to dry. If you apply the hair while the glue is still wet, it will just fall off. You want the glue to be tacky. Do not touch the glue. You’ll get a feel for how long this takes. 
While the glue is tacking up, Use a comb to comb through the last inch or so of you ironed crepe hair. You will lose hair in the comb. That’s okay. 
Spread the hair out between your fingers so it is more sparse (and natural looking). And cut off at least an inch of hair (more if you want your beard to be longer). Do not make it shorter, you will trim your beard later!
Apply the hair to your face using the tip of the handle of your paintbrush to lightly tap the hair into the tacky glue. Ta-da!  There’s your first bit of beard.
Repeat Steps 5-10 until you have all the facial hair you want!
If you did everything right, you probably look like a mountain man at this point. Using your comb, lift the beard hairs so they are about a 45 degree angle to your face and start trimming with a scissors. You may find at this point that you missed some patches, don’t worry! Just repeat steps 5-10 on the patchy part, being very careful not to get glue on the parts you’ve already glued down.
Using your hands, brush the hair downward into a natural beard growth. I like to lightly spray my face with hairspray at this point.
For an extra bit of realism, Use a stipple sponge to tap some make up around the edges of the beard so it looks like stubble.
All done! If you did your beard well, people can even tug on it and it won’t come off (trust me, this happens to me nearly every time someone realizes I’m actually female).
To remove your beard, soak a cotton ball with adhesive remover and soak your beard with remover. Let it sit for a minute so it has a chance to soften the glue. Start scraping that hair off. It will probably take a few rounds of soaking the glue and scrubbing.
Practice. Don’t do this for the first time at the convention. I’ve applied more beards than I can count, and it gets better every time I do it.
Reblogging my old tutorial for the asks I got about my beard application. I’ve been changing up my technique a little, so I need to write a new one, but the same steps pretty much apply. Just a few additional notes:
Apply your beard sparsely. If you observe beards in the wild, you can usually see a bit of skin in between the hairs.
Observe lots of beards. If you have friends that have beards, look at them closely. You will see that there are lots of different colors mixed in and that the hair is sparser in certain areas. Try to replicate this when you’re applying your beard.
Use a photo reference of the character you are trying to recreate while you are applying your beard. Make notes of where the beard is in relationship to landmarks on your face (nose, corners of the mouth, etc)
You can use a beard to change the contours of your face. For example I laid my hair in with hard edges when I did my Oberyn makeup test in order to make it look like I have a squarer chin. 
Practice, practice, practice. I’ve been applying beards on myself since 2007, and some of the early ones were pretty terrible. 
Beard application can take a couple of hours (or more if it’s your first time) so leave yourself plenty of time so you aren’t rushed.

Reblogging because this is hella great.

As a dude who has trouble growing a beard and has several costumes that call for one, this is something I want to try.

pitoftharkun:

teadrunktailor:

feralworks:

Steps are as follows:

  1. Buy some crepe wool. It comes in a braid and most places let you buy it by the inch. I usually buy 2 feet at a time, but you’re probably only gonna need around 4 inches for one beard (get extra! you don’t want to run out mid application!) I buy mine from a local costume shop, but lots of places sell it online.
  2. Unravel about 6-7 inches of the braid. You’ll notice that the hair is super wavy. You need to iron it first! Don’t skip this step or you’re going to end up with one crazy beard. I sandwich the braid in between two pieces of broadcloth so the iron isn’t actually touching the hair, spritz the cloth with water. Put the iron on the end of the hair and pulling the rest of the braid to straighten it, then move the iron up the length of the hair. In the end it will still have a little bit of a wave to it, but nothing like before.
  3. Clean your face really well! Any residue or oil is going to cause the adhesive to have trouble sticking.
  4. Adhesive: I use Prosaide. You can use other adhesives like spirit gum, but I’ve found that it doesn’t hold as well and tends to need to be touched up throughout the day. Prosaide is a medical grade adhesive and sticks like nobody’s business.  Be sure to buy some adhesive remover for later too!
  5. Start applying the adhesive to your sparkling clear face. I usually only apply about a square inch or two at a time. Paint it on using a cheap paint brush (you will probably throw this away afterwards) in the shape of your beard. Do not touch the glue. It is super sticky and will stick to everything. I start with my chin (underchin).
  6. You want to work your way from the bottom to the top. This is important because you will be layering the beard and it’s easier to lay the hair on top than to try to get it underneath the previous layer.
  7. Allow the glue to dry. If you apply the hair while the glue is still wet, it will just fall off. You want the glue to be tacky. Do not touch the glue. You’ll get a feel for how long this takes. 
  8. While the glue is tacking up, Use a comb to comb through the last inch or so of you ironed crepe hair. You will lose hair in the comb. That’s okay. 
  9. Spread the hair out between your fingers so it is more sparse (and natural looking). And cut off at least an inch of hair (more if you want your beard to be longer). Do not make it shorter, you will trim your beard later!
  10. Apply the hair to your face using the tip of the handle of your paintbrush to lightly tap the hair into the tacky glue. Ta-da!  There’s your first bit of beard.
  11. Repeat Steps 5-10 until you have all the facial hair you want!
  12. If you did everything right, you probably look like a mountain man at this point. Using your comb, lift the beard hairs so they are about a 45 degree angle to your face and start trimming with a scissors. You may find at this point that you missed some patches, don’t worry! Just repeat steps 5-10 on the patchy part, being very careful not to get glue on the parts you’ve already glued down.
  13. Using your hands, brush the hair downward into a natural beard growth. I like to lightly spray my face with hairspray at this point.
  14. For an extra bit of realism, Use a stipple sponge to tap some make up around the edges of the beard so it looks like stubble.
  15. All done! If you did your beard well, people can even tug on it and it won’t come off (trust me, this happens to me nearly every time someone realizes I’m actually female).
  16. To remove your beard, soak a cotton ball with adhesive remover and soak your beard with remover. Let it sit for a minute so it has a chance to soften the glue. Start scraping that hair off. It will probably take a few rounds of soaking the glue and scrubbing.
  17. Practice. Don’t do this for the first time at the convention. I’ve applied more beards than I can count, and it gets better every time I do it.

Reblogging my old tutorial for the asks I got about my beard application. I’ve been changing up my technique a little, so I need to write a new one, but the same steps pretty much apply. Just a few additional notes:

  • Apply your beard sparsely. If you observe beards in the wild, you can usually see a bit of skin in between the hairs.
  • Observe lots of beards. If you have friends that have beards, look at them closely. You will see that there are lots of different colors mixed in and that the hair is sparser in certain areas. Try to replicate this when you’re applying your beard.
  • Use a photo reference of the character you are trying to recreate while you are applying your beard. Make notes of where the beard is in relationship to landmarks on your face (nose, corners of the mouth, etc)
  • You can use a beard to change the contours of your face. For example I laid my hair in with hard edges when I did my Oberyn makeup test in order to make it look like I have a squarer chin. 
  • Practice, practice, practice. I’ve been applying beards on myself since 2007, and some of the early ones were pretty terrible. 
  • Beard application can take a couple of hours (or more if it’s your first time) so leave yourself plenty of time so you aren’t rushed.

Reblogging because this is hella great.

As a dude who has trouble growing a beard and has several costumes that call for one, this is something I want to try.

2 hours ago on September 19th | J | 122 notes

schweizercomics:

yamino:

thedragonflywarrior:

The Body Shapes of the World’s Best Athletes Compared Side By Side

Health and fitness comes in all shapes and sizes. Every single one of these athletes is a certified bad-ass.

I’ve posted this before but it’s worth reblogging!

Just a reminder - if you’re drawing a team superhero book and more than one of your characters has the same build YOU’RE DOING IT ALL WRONG

2 hours ago on September 19th | J | 37,244 notes

jamesfactscalvin:

Good Lord Peter

2 hours ago on September 19th | J | 168,742 notes

thewinterwidow:

How are Remus and Sirius not meant to be together when Remus is the moon and Sirius is the stars?

2 hours ago on September 19th | J | 6,931 notes

My Cat ran away

onepandaparfait:

bonerstew:

Hey internet
a few days ago my cat Jack ran away and hasn’t been home
We are very worried about him 
He’s a big skinny black cat and he has a red collar. 
We live in Wilmington, North Carolina. 
if you find him please email me, im worried sick about him. 
Bonniehcsilver@gmail.com

image

Hey guys! Please help my friend find her cat!

2 hours ago on September 19th | J | 21 notes
thug-shinji:

Shinji having fun at the local park

thug-shinji:

Shinji having fun at the local park

2 hours ago on September 19th | J | 10,937 notes

wellyesyoumay:

nethilia:

utterlyimpossible:

mildrevolution:

Greek/Roman Inspired Clothing:  2nd dress by Hana Touma, 3rd dress on ebay, 4th dress found here, 5th dress by Madame Gres ,6th dress by Kaufman Franco  , 7th dress by J.Mendel, 8th dress by Madame Gres, 9th dress by Jean Desses, 10th dress by Marchesa, 11th dress by 33Jewls, 12th (last) dress by Samuelle Couture

Things I would wear were I a Goddess

whatchu mean “if I were”

I need to start sewin’.

4 hours ago on September 19th | J | 43,284 notes
brownkitten:

welcome to art school

brownkitten:

welcome to art school

4 hours ago on September 19th | J | 2,096 notes

reblog if you are a NERD who loves DRAGONS

4 hours ago on September 19th | J | 72,239 notes

sashaforthewin:

silentshivers:

literally how does anyone not believe in aliens

are u really so anthropocentric that you think there are millions and billions and trillions of light years of the ever expanding universe but we’re the only life to possibly exist smh

I believe life exists elsewhere. I have a damn hard time believing any would waste their time coming to visit us.

4 hours ago on September 19th | J | 117,226 notes

losethehours:

cryingalonewithfrankenstein:

do-you-have-a-flag:

i probably shouldn’t quote this bit as often as I do

this is one of my favorite jokes ever

no really

ever

Me too.

4 hours ago on September 19th | J | 41,560 notes

bellechere:

tallythor:

nashcon-castiel:

"They call me terrorist. Radical. Zealot … because I obey the ancient laws of my people, the Kree, and punish those who do not."

Ronan the Accuser - Guardians of the Galaxy

photo credit to Dru Phillips and AMPCosplay Community

CAN’T GET OVER HER!

*chokes* This is a cosplay, guys.

THIS IS A COSPLAY.

THIS IS NOT LEE PACE. THIS IS NOT ON A MOVIE SET. THIS IS A FAN.

4 hours ago on September 19th | J | 1,236 notes
deanshuggybear:

fozmeadows:

In which seven cats all discover the same slightly elevated flat thing and claim it as their own while pretending the other six cats don’t exist.

game of thrones

deanshuggybear:

fozmeadows:

In which seven cats all discover the same slightly elevated flat thing and claim it as their own while pretending the other six cats don’t exist.

game of thrones

4 hours ago on September 19th | J | 318,702 notes
4 hours ago on September 19th | J | 11 notes

valderie:

need

13 hours ago on September 19th | J | 22,423 notes